Cisco NCS 2000 series Troubleshooting Manual page 567

Error Messages
Error/Warning
ID
EID-5011
WID-5012
EID-5013
EID-5014
WID-5015
EID-5016
EID-5017
EID-5018
EID-5019
EID-5020
EID-5021
WID-5022
EID-5023
EID-5024
Error/Warning Message
The domain name cannot exceed {0} characters.
The software load on {0} does not support the addition
of a node to a 1+1 protection group.
{0} does not support the bridge and roll feature. Please
select a different port.
An automatic network layout is already in progress.
Please wait for it to complete before running it again.
{0} cannot be applied to {1}.
An error occurred while attempting to provision the
{0}. {1}
Provisioning could not be rolled back. The {0} might
be left in an INCOMPLETE state and should be
manually removed.
{0} is a(n) {1} node and cannot be added to a(n) {2}
network.
The manual path trace mode for this equipment does
not support an expected string consisting of all null
characters. Please change the expected string or the
path trace mode.
Software activation is in progress. Provisioning is not
allowed.
Software activation is in progress. {0} is not allowed.
Warning: Ethergroup circuits are stateless (that is,
always in service). The current state selection of {0}
will be ignored.
CTC cannot communicate with the node. The operation
failed.
The overhead circuit will not be upgraded.
Description
You may have reached the maximum
number of characters.
Refer to the warning message text.
The specified port does not support
Bridge and Roll.
You must for the automatic network
layout to complete before running it
again.
You cannot apply the admin state
operation, specified by {0}, to port
count, specified by {1}.
CTC encountered an error while
provisioning the card.
You may have to remove the BLSR
manually as it was left incomplete.
You cannot add the node {0} of type
{1} to the host node of type {2}. This
prevents you from hosting both
SONET and SDH nodes in the same
session.
The path trace mode does not support
strings that consist of null characters.
You must either change the expected
string or the path trace mode.
Refer to the warning message text.
Refer to the error message text.
Refer to the warning message text.
CTC encountered a network
communication error. Connectivity
between CTC and the NE was
disrupted, either transiently or
permanently.
Refer to the error message text.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
Error Messages Reference
521