Cisco NCS 2000 series Troubleshooting Manual page 553

Error Messages
Error/Warning
ID
EID-3189
EID-3214
EID-3215
EID-3216
EID-3217
EID-3218
EID-3219
EID-3220
EID-3222
EID-3225
EID-3226
EID-3227
EID-3228
EID-3229
EID-3230
EID-3231
WID-3232
Error/Warning Message
The sum of the {0} must be between {1} and {2}.
The number of high order circuits for the line could not
be retrieved.
An error occurred while refreshing.
The proxy port is invalid.
The statistics could not be refreshed.
The automatic node setup could not be launched.
The automatic node setup information could not be
refreshed.
An error occurred while refreshing row {0}.
The statistics could not be cleared.
An error occurred while refreshing the pane.
The {0} termination(s) could not be deleted. {1}
A baseline could not be recorded. Performance metrics
will remain unchanged.
The {0} termination(s) could not be created. {1}
RIP is active on the LAN. Please disable RIP before
enabling OSPF.
OSPF is active on the LAN. Please disable OSPF before
enabling RIP.
An error occurred while setting the OPR.
The port state cannot be indirectly transitioned because
the port is still providing services. If the port state
should be changed, edit it directly through port
provisioning.
Description
Refer to the error message text.
The number of High Orders
(STS/STM) for the line is not
available.
Used frequently in pane classes to
indicate a general error condition when
trying to refresh from the model.
Refer to the error message text.
CTC could not refresh statistics
values.
Refer to the error message text.
Failure trying to retrieve automatic
node setup information.
Error refreshing the specified row.
Refer to the error message text.
Used frequently in pane classes to
indicate a general error condition when
trying to refresh from the model.
Refer to the error message text.
CTC failed to set the baseline values
while provisioning NE. Previous
values remain unchanged.
Refer to the error message text.
Turn off the Routing Information
Protocol (RIP) on the LAN, before
enabling OSPF.
Turn off the OSPF on the LAN before
enabling RIP.
An error was encountered while
attempting to provision the optical
power received (OPR).
Edit the port state while provisioning
the port.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
Error Messages Reference
507