Clear The Eqpt-Degrade Condition - Cisco NCS 2000 series Troubleshooting Manual

Clear the EQPT-DEGRADE Condition

Clear the EQPT-DEGRADE Condition
SUMMARY STEPS
1. Remove and reinsert the card where the EQPT-DEGRADE condition is raised. If the reinsertion does not
clear the alarm, replace the card. Complete the
the card.
DETAILED STEPS
Remove and reinsert the card where the EQPT-DEGRADE condition is raised. If the reinsertion does not clear the alarm,
replace the card. Complete the
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
EQPT-DIAG
Default Severity: Critical (CR), Service-Affecting (SA)
Logical Object: EQPT
An Equipment-Diagnostic Failure alarm indicates that a software or hardware failure has occurred on the
reporting card. This alarm can be raised against a traffic card or a cross-connect card.
Clear the EQPT-DIAG Alarm
SUMMARY STEPS
1. If traffic is active on the alarmed card, you could need to switch traffic away from it. Refer to the
Switching, Lock Initiation, and Clearing, on page 443
2. Complete the
3. If the alarm does not clear, complete the
against a traffic card, or complete the
alarm is raised against the cross-connect card.
DETAILED STEPS
Step 1
If traffic is active on the alarmed card, you could need to switch traffic away from it. Refer to the
Lock Initiation, and Clearing, on page 443
Step 2
Complete the Remove and Reinsert (Reseat) Any Card , on page 452
Step 3 If the alarm does not clear, complete the
card, or complete the
cross-connect card.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
182
Physically Replace a Card, on page 453
Remove and Reinsert (Reseat) Any Card , on page 452
section for procedures.
Physically Replace a Card, on page 453
Generic Signal and Circuit Procedures, on page 454
Physically Replace a Card, on page 453
procedure to replace the card.
http://www.cisco.com/c/en/us/support/index.html
section for procedures.
Physically Replace a Card, on page 453
Generic Signal and Circuit Procedures, on page 454
procedure for the alarmed card
procedure if the alarm is raised against the
Alarm Troubleshooting
procedure to replace
procedure for the alarmed card
procedure if it is raised
procedure if the
Protection Switching,
procedure if it is raised against a traffic
Protection