Cisco NCS 2000 series Troubleshooting Manual page 582

Error Messages Reference
Error/Warning
ID
EID-6050
WID-6051
EID-6052
EID-6053
EID-6054
EID-6055
EID-6056
WID-6057
EID-6058
EID-6059
EID-6060
EID-6061
EID-6062
EID-6063
EID-6064
EID-6065
EID-6066
EID-6067
EID-6068
EID-6069
EID-6070
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
536
Error/Warning Message
Some {0} terminations were not {1}d. {2}
All {0} terminations were {1}d successfully. {2}
The authentication key can not be blank.
No more SNMP trap destinations can be created.
{0} is not a valid IP address for an SNMP trap
destination.
The IP address is already in use.
The SNMP trap destination is invalid. {0}
Changing the card mode will result in an automatic
reset.
The maximum number of IP-over-CLNS tunnels has
been exceeded.
The specified IP-over-CLNS tunnel already exists!
An error occurred while trying to {0} an IP-over-CLNS
tunnel entry: {1}.
An error occurred while deleting the IP-over-CLNS
tunnel entry.
The selected IP-over-CLNS tunnel does not exist.
The selected router does not exist.
The MAA address list is full.
The selected area address is duplicated.
The primary area address cannot be removed.
The selected area address does not exist.
The IP-over-CLNS NSEL cannot be modified while
there are IP-over-CLNS tunnel routes provisioned.
The node is currently in ES mode. Only Router 1 can
be provisioned.
No router was selected.
Error Messages
Description
Refer to the error message text.
Refer to the warning message text.
Enter an authentication key.
You have reached the maximum
number of SNMP trap destinations.
The IP address specified is not a valid
receiver of SNMP traps.
Refer to the error message text.
The specified SNMP trap destination
is invalid. Choose another destination.
Refer to the warning message text.
Refer to the error message text.
Specify another IP Over CLNS tunnel.
Refer to the error message text.
CTC encountered an error while
deleting the IP Over CLNS tunnel
entry.
Create a IP Over CLNS tunnel.
Create a router.
Refer to the error message text.
Enter another area address.
Refer to the error message text.
Choose another area address.
You cannot change the NSEL address
if tunnels are provisioned.
An End System needs only one
provisioned router.
Select a router.