Cisco NCS 2000 series Troubleshooting Manual page 595

Error Messages
Error/Warning
ID
EID-6326
EID-6327
EID-6329
EID-6330
EID-6331
WID-6332
WID-6333
WID-6334
WID-6335
WID-6336
WID-6337
WID-6338
WID-6339
Error/Warning Message
The CRS node {0} version[{1}] is greater than the
supported version[{2}]. The creation of ochtrail circuits
between CRS nodes will not be disabled, but there could
be unexpected behaviors.
The end point of patchcord have an incompatible
wavelength.
Protection/AIS action cannot be both set to squelch.
The node failed to restart the Pseudo IOS CLI service
on the selected port. Try using another unreserved port
that is not being used within the 1024 - 65535 range.
That port is already in use. Also note that the Pseudo
IOS port may not be changed if any Pseudo IOS
connections are currently open.
All previously configured IPv6 destinations will become
unreachable if IPv6 mode is disabled. It is
recommended that you remove all IPv6 related
provisioning before disabling IPv6 mode. Do you want
to continue?
The NE default {0} not available in the selected NE
Defaults Tree.
Could not find the NE default {0}.
CTC was unable to create a new Target account.
Changing the card to EFEC mode will cause the ports
1 and 2 to be disabled. Do you want to continue?
CE-MR-10/CE-MR-6 card does not validate the
Ethernet FCS when traffic is received from optical side.
This can result in errored frames from optical side being
forwarded to the peer device via front ports. It would
be left to the peer device to detect the errors and discard
the frames. It is suggested to enable the FCS option on
both ends of the circuit. The GFP FCS will be used to
discard errored frames. The discarded frames will be
accounted under the performance pane for the POS
port.
Ingress COS setting is not compatible with QinQ mode.
Some circuits may become partial as part of this
upgrade and would need to be reconfigured.
Description
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the warning message text.
Refer to the warning message text.
Refer to the warning message text.
Refer to the warning message text.
Refer to the warning message text.
Refer to the warning message text.
Refer to the warning message text.
Refer to the warning message text.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
Error Messages Reference
549