Peer-Cert-Verification-Failed - Cisco NCS 2000 series Troubleshooting Manual

PEER-CERT-VERIFICATION-FAILED

Step 7
If the condition does not clear, clean the far-end optical fiber according to site practice. If no site practice exists, complete
the procedure in the Maintain the Node chapter of the Configuration guide.
Step 8 If the condition does not clear, complete the
cards.
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
PEER-CERT-VERIFICATION-FAILED
Default Severity: Major (MJ), Non-Service-Affecting (NSA)
Logical Object: OTN
The Peer Certificate Verification Failed alarm is raised when the verification of a peer certificate in the card
fails.
Clear the PEER-CERT-VERIFICATION-FAILED Alarm
This alarm is cleared when the verification of a peer certificate in the card is pass.
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
PEER-CSF
Default Severity: Major (MJ), Service-Affecting (SA)
Logical Object: STM/OCN
The Peer Client Signal Fail alarm that is a secondary alarm raised on local OCN, OTU1, or SDI_3G_VIDEO
ports when a remote Service-Affecting (SA) alarm causes an invalid data transmission. The alarm is raised
locally on AR_MXP and AR_XP ports and does not indicate that a Service-Affecting (SA) failure has occured
at the local site. Instead it indicates that an alarm such as LOS, LOS-P, LOF, OTU-AIS is caused by an event
affecting the transmission capability of the remote port.
Clear the PEER-CSF Alarm
SUMMARY STEPS
1. Clear the Service-Affecting (SA) alarm at the remote data port.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
354
Physically Replace a Card, on page 453
http://www.cisco.com/c/en/us/support/index.html
http://www.cisco.com/c/en/us/support/index.html
Alarm Troubleshooting
procedure for the optical/electrical