Feed-Mismatch - Cisco NCS 2000 series Troubleshooting Manual

Alarm Troubleshooting
DETAILED STEPS
Step 1
In node view (single-shelf mode) or shelf view (multishelf mode), double-click the TXP_MR_10G, TXP_MR_10E,
TXP_MR_10E_C, TXP_MR_10E_L, TXP_MR_2.5G, TXPP_MR_2.5G, MXP_MR_10G, MXP_MR_10E, ADM-10G,
and OTU2_XP card.
Step 2 Click the Provisioning > OTN > OTN Lines tabs.
Step 3
In the FEC column, click Enable to activate the FEC feature. This causes a different OTN frame to be transmitted.
Alternately, in the E-FEC column (TXP_MR_10E and MXP_MR_10E), click Enable to activate the Enhanced FEC
feature.
Step 4
Verify that the far-end card is configured the same way by repeating
If the alarm does not get cleared, you need to report a Service-Affecting (SA) problem. Log into the Technical Support
Website at http://www.cisco.com/c/en/us/support/index.html
en/us/support/web/tsd-cisco-worldwide-contacts.html
your country.

FEED-MISMATCH

Default Severity: Major (MJ), Service Affecting (SA)
Logical Objects: EQPT
The Feed Mismatch alarm is raised when the mandatory power module input feed based on Power Supply
Unit (PSU) configuration is disconnected or incorrectly connected.
The alarm is cleared when the mandatory feed connection of power module is connected as per the PSU
configuration. To re-configure the feed connection, refer to
FEPRLF
Default Severity: Minor (MN), Non-Service-Affecting (NSA)
Logical Object: OCN
The Far-End Protection Line Failure alarm occurs when there was an
on the protect card APS channel coming into the node.
Note The FEPRLF alarm occurs on the NCS only when bidirectional protection is used on optical (traffic) cards
in a 1+1 protection group configuration.
Step 1, on page 201
for more information or log into
to obtain a directory of toll-free Technical Support numbers for
Power Redundancy
SF (TRUNK) , on page 390
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
FEED-MISMATCH
through Step 3, on page 201.
http://www.cisco.com/c/
.
condition
201