Eval-Lic - Cisco NCS 2000 series Troubleshooting Manual

Alarm Troubleshooting
Step 2
If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/techsupport for more
information or call Cisco TAC 1 800 553-2447.

EVAL-LIC

Default Severity: Minor (MN), Non-Service-Affecting (NSA)
Logical Object: EQPT
The Evaluation License (EVAL-LIC) alarm is raised to indicate that an valid evaluation license is in use.
Clear the EVAL-LIC Alarm
SUMMARY STEPS
1. Procure and install a permanent license. For more information on installing a license, see the Licensing
Configuration Guide.
DETAILED STEPS
Procure and install a permanent license. For more information on installing a license, see the Licensing Configuration
Guide.
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
EXC-BP
Default Severity: Minor (MN), Non-Service-Affecting (NSA)
Logical Objects: OTS
The Excessive Back Propagation condition occurs due to excessive backscattered Raman pump power at the
LINE-RX connector. This condition is caused either due to a dirty connector, bad optical patch panel connection,
or disconnected LINE-RX connector. When the EXC-BP alarm is raised, the level of backscattered power is
at a hazardous level, with the risk of possible damage to the unit and/or the external equipment.
Clear the EXC-BP Condition
SUMMARY STEPS
1. Verify all the fibers between the LINE RX and patch-panel are connected.
2. Clean the connectors using site practices or, if none exists, complete the procedure in the Maintain the
Node chapter of the Procedure Guide.
http://www.cisco.com/c/en/us/support/index.html
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
EVAL-LIC
187