Cisco NCS 2000 series Troubleshooting Manual page 584

Error Messages Reference
Error/Warning
ID
EID-6088
EID-6089
EID-6090
EID-6091
EID-6092
EID-6093
EID-6094
EID-6095
EID-6096
EID-6097
EID-6098
EID-6099
WID-6100
EID-6101
WID-6102
EID-6103
EID-6104
EID-6105
EID-6106
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
538
Error/Warning Message
This line cannot be put into loopback while it is in use
as a timing source.
The interface was not found. {0}
The interface type is not valid for this operation. {0}
The current state of the interface prohibits this
operation. {0}
This operation is prohibited for this interface. {0}
The maximum number of TARP data cache entries has
been exceeded.
The maximum number of manual adjacency table
entries has been exceeded.
The AIS/Squelch mode is invalid.
A default IP-over-CLNS tunnel route is only allowed
on a node without a default static route and a default
router of 0.0.0.0.
The authorization key does not comply with Cisco IOS
password restrictions. {0}
A default static route is not allowed when a default
IP-over-CLNS tunnel exists.
You cannot create a subnet on a disabled router.
Disabling a router that has a provisioned subnet is not
recommended.
The MAT entry already exists.
The new card has less bandwidth than the current card.
Circuits of size VT15 and larger will be deleted.
The TDC entry already exists.
APC ABORTED.
The 'Change Card' command is valid for MRC cards
only when Port 1 is the sole provisioned port.
To delete all RADIUS server entries, RADIUS
authentication must be disabled.
Error Messages
Description
Refer to the error message text.
CTC cannot find the specified
interface.
Choose another interface.
The port is in an invalid state to set a
loopback.
CTC does not allow this operation for
the specified interface.
You have exceeded the number of
characters permitted.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Specify another authorization key.
Refer to the error message text.
Create the subnet on an active router.
Refer to the warning message text.
Refer to the error message text.
Refer to the warning message text.
Specify another entry for TARP Data
Cache.
Automatic Power Control is aborted.
Refer to the error message text.
Disable Radius authentication and
proceed.