Cisco NCS 2000 series Troubleshooting Manual page 585

Error Messages
Error/Warning
ID
EID-6107
EID-6108
EID-6109
EID-6110
EID-6111
EID-6112
EID-6113
EID-6114
EID-6115
EID-6116
EID-6117
WID-6118
Error/Warning Message
The node failed to restart the TELNET service on the
selected port. Try using another unreserved port that is
not being used within the following ranges: 23,
1001-9999 (with the exception of 1080, 2001-2017,
2361, 3081-3083, 4001-4017, 4022, 4081, 4083, 5000,
5001, 7200, 9100, 9300, 9401).
That port is already in use.
A section trace is active on the trunk port. The action
cannot be completed.
The maximum number of TARP requests has been
reached.
The card in Slot {0} cannot be removed from the
protection group while its traffic is switched.
An error occurred while adding a shelf: {0}
An error occurred while deleting a shelf: {0}
The maximum number of supported shelves has already
been provisioned.
There are bad or duplicate shelf positions. Valid rack
numbers are {0} to {1}. Valid rack positions are {2}
to {3}.
CTC attempted to access an OCH-Trail connection that
has been destroyed.
CTC attempted to access an OCH-Trail audit that has
been destroyed.
The following slots are provisioned but do not have
cards installed: {0} CTC will assume they are ITU-T
interfaces.
Description
Refer to the error message text.
Restart a TELNET session.
Actions such as putting the port in an
incomplete state are not permitted
while a section trace is active.
You have exceeded the maximum
number of TARP requests.
Refer to the error message text.
The shelf ID specified is invalid or
already exists, the equipment does not
support multishelf, the specified shelf
position is out of range, or the
specified shelf position is already in
use.
One or more of the equipment
modules (provisioned virtual links,
provisioned server trails, provisioned
protection groups, or provisioned
DCCs) in the shelf is currently in use.
Delete cards from all the slots and try
again.
Refer to the error message text.
Refer to the error message text.
Software has prevented an attempt to
access an OCH trail.
The resource cannot be accessed
because it is released or fully utilized.
Refer to the warning message text.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
Error Messages Reference
539