Cisco NCS 2000 series Troubleshooting Manual page 534

Error Messages Reference
Error/Warning
ID
EID-2093
EID-2094
EID-2095
EID-2096
EID-2097
EID-2099
EID-2100
EID-2101
EID-2102
EID-2103
EID-2104
EID-2106
EID-2107
EID-2108
EID-2109
EID-2110
EID-2111
EID-2113
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
488
Error/Warning Message
The name is too short. It does not have enough
characters. {0}
The password and confirmed password fields do not
match.
The password is invalid. {0}
The user must have a security level.
No user name was specified.
An error occurred while ring switching.
Please select at least one profile to delete.
An error occurred while protection switching.
The forced switch could not be removed for some
circuits. You must switch these circuits manually.
An error occurred while upgrading the span.
The circuits cannot be switched back because one or
both nodes are not reachable.
The node name cannot be empty.
An error occurred while adding {0}. The host is
unknown.
{0} is already in the network.
The node is already in the current login group.
Please enter a number between 0 and {0}.
This node ID is already in use. Please choose another.
The extension byte for the ring cannot be set. {0}
Error Messages
Description
The name must have a minimum of
six characters.
You must make sure the two fields
have the same password.
The password you entered is not
allowed.
You must have an assigned security
level to perform this task.
You did not specify a user name.
There was an error during the ring
switch.
You have not selected the profile to
delete.
There was an error during the
protection switching.
The forced switch could not be
removed for some circuits. You must
switch these circuits manually.
There was an error during the span
upgrade.
This error occurs during the path
protection span upgrade procedure.
You must supply a name for the node.
There was an error adding the
specified item.
The specified item exists in the
network.
The node you are trying to add is
already present in the current login
group.
You must enter a number in the range
between 0 and the specified value.
Select a node ID that is not in use.
CTC cannot set the BLSR/MS-SPRing
extension byte.