Carloss (Fc) - Cisco NCS 2000 series Troubleshooting Manual

Alarm Troubleshooting

CARLOSS (FC)

Default Severity: Major (MJ), Service-Affecting (SA)
Logical Object: FC
The Carrier Loss for Fibre Channel (FC) alarm occurs on the client port of a TXP_MR_10G, TXP_MR_10E,
TXP_MR_10E_C, TXP_MR_10E_L, TXP_MR_2.5G, TXPP_MR_2.5G, MXP_MR_2.5G, MXPP_MR_2.5G,
MXP_MR_10DME_C, MXP_MR_10DME_L, supporting 1-Gb Fibre Channel (FC1G), 2-Gb FC (FC2G),
or 10Gb Fiber Channel (10G Fiber Channel) traffic. The loss can be due to a misconfiguration, fiber cut, or
client equipment problem.
Clear the CARLOSS (FC) Alarm
SUMMARY STEPS
1. Complete the
DETAILED STEPS
Complete the Clear the CARLOSS (GE) Alarm, on page 149
If the alarm does not get cleared, you need to report a Service-Affecting (SA) problem. Log into the Technical Support
Website at http://www.cisco.com/c/en/us/support/index.html
en/us/support/web/tsd-cisco-worldwide-contacts.html
your country.
CARLOSS (GE)
Default Severity: Major (MJ), Service-Affecting (SA)
Logical Object: GE
The Carrier Loss for Gigabit Ethernet (GE) alarm occurs on the client port of a TXP_MR_10G, TXP_MR_10E,
TXP_MR_10E_C, TXP_MR_10E_L, TXP_MR_2.5G, TXPP_MR_2.5G, MXP_MR_2.5G, MXPP_MR_2.5G,
MXP_MR_10DME_C, MXP_MR_10DME_L, GE-XP, 10GE-XP, or ADM-10G cards supporting 1-Gbps
or 10-Gbps traffic. The loss can be due to a misconfiguration, fiber cut, or client equipment problem.
Clear the CARLOSS (GE) Alarm
SUMMARY STEPS
1. Ensure that the GE client is correctly configured:
2. If there is no PPM (SFP) misprovisioning, check for a fiber cut. An LOS alarm would also be present. If
there is an alarm, complete the Clear the LOS (OCN/STMN) Alarm procedure located in Chapter 2, Alarm
Troubleshooting, of the Troubleshooting guide.
Clear the CARLOSS (GE) Alarm, on page 149
to obtain a directory of toll-free Technical Support numbers for
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
procedure.
procedure.
for more information or log into
CARLOSS (FC)
http://www.cisco.com/c/
149