Rep-Stcn-Generated - Cisco NCS 2000 series Troubleshooting Manual

Transient Conditions

REP-STCN-GENERATED

The REP-STCN-GENERATED condition occurs in GE_XP and 10GE_XP cards on an edge port with STCN
segment or port provisioning after a topology change in the REP segment. The condition is raised on the edge
port of the segment.
REP-VLB-ACTIVATED
The REP-VLB-ACTIVATED condition occurs in GE_XP and 10GE_XP cards when VLB is already
provisioned on the primary edge, and activation is triggered. The condition is raised on the primary edge port
of the segment.
REP-VLB-TRIG-DELAY
The REP-VLB-TRIG-DELAY condition occurs in the GE_XP and 10GE_XP cards when the VLB trigger
delay timer is started on the primary edge port. The condition is raised on the primary edge port of the segment.
RESTORE-IN-PROG
The Restoration in Progress (RESTORE-IN-PROG) condition occurs when the WSON initiates a path switch
during a restoration of a GMPLS circuit. This condition demotes all outstanding alarms on the path across
the entire network. The condition is cleared after a timeout of five minutes.
RMON-ALARM
The Remote Monitoring Threshold Crossing Alarm (RMON-ALARM) condition occurs when the remote
monitoring (RMON) variable crosses the threshold.
RMON-RESET
The RMON Histories and Alarms Reset Reboot (RMON-RESET) condition occurs when the time-of-day
settings on the control card are increased or decreased by more than five seconds. This invalidates all the
history data, and RMON must restart. It can also occur when you reset a card.
SESSION-TIME-LIMIT
The Session Time Limit Expired (SESSION-TIME-LIMIT) condition occurs when a login session exceeds
the time limit and you are logged out of the session. You must log in again.
SFTWDOWN-FAIL
The Software Download Failed (SFTDOWN-FAIL) condition occurs when the system fails to download the
required software package.
An incorrect input that points to the wrong place or file, network issues, or a bad (corrupt) software package
can cause this failure. If the software package is corrupt, contact the Cisco Technical Assistance Center (TAC)
(1 800 553-2447) for assistance.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
REP-STCN-GENERATED
475