Cisco NCS 2000 series Troubleshooting Manual page 531

Error Messages
Error/Warning
ID
EID-2037
EID-2038
EID-2040
EID-2041
EID-2042
EID-2043
EID-2044
EID-2045
EID-2047
EID-2048
EID-2050
EID-2051
EID-2052
EID-2054
EID-2055
Error/Warning Message
The attribute for {0} cannot be found.
The protection operation is invalid.
Please select a node first.
No paths are available on this link. Please make another
selection.
This span is not selectable. Only the green spans with
an arrow may be selected.
This node is not selectable. Only the source node and
nodes attached to included spans (blue) are selectable.
Selecting a selectable node will enable its available
outgoing spans.
This link may not be included in the required list.
Constraints only apply to the primary path. Each node
may have a maximum of one incoming signal and one
outgoing link.
This link may not be included in the required list. Only
one outgoing link may be included for each node.
Please enter a valid value for the slot number.
Please enter a valid value for the port number.
The new circuit could not be destroyed.
The circuit cannot be downgraded. {0}
An error occurred during circuit processing.
An error occurred while selecting an endpoint.
No endpoints are available for this selection. Please
make another selection.
Description
CTC cannot find an attribute for the
specified item.
The protection operation you tried to
execute is invalid.
You must select a node before
performing the task.
You must select a link that has paths
available.
Refer to the error message text.
Refer to the error message text.
You must select only one link going
in and out of a node. Selecting more
than one link is contradictory to the
path selection algorithm.
Refer to the error message text.
There was an error due to an invalid
slot number.
There was an error due to an invalid
port number.
CTC could not destroy the new circuit.
The specified circuit cannot be
downgraded.
There was an error during the circuit
processing.
There was an error during the endpoint
selection.
This error occurs in the circuit creation
dialog only during a race condition
that has incorrectly allowed entities
without endpoints to be displayed in
the combination boxes.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
Error Messages Reference
485