Cisco NCS 2000 series Troubleshooting Manual page 555

Error Messages
Error/Warning
ID
EID-3247
EID-3248
EID-3249
EID-3250
EID-3251
EID-3252
EID-3253
EID-3254
EID-3255
WID-3256
EID-3257
EID-3258
EID-3259
EID-3260
EID-3261
EID-3262
Error/Warning Message
An ordering error occurred. The absolute value should
be {0}.
The value for the parameter {0} is invalid.
The voltage increment value is invalid.
The power monitor range is invalid.
The requested action could not be completed. {0}
No download has been initiated from this CTC session.
The reboot operation failed. {0}
An error occurred during validation. {0}
You cannot change the timing configuration because a
Manual/Force operation is in effect.
The timing reference(s) could not be assigned because
one or more of the timing reference(s): - is already used
and/or - has been selected twice and/or - is attempting
to use the same slot twice. Please verify the settings.
Duplicate DCC numbers are not permitted. {0}.
A software error occurred while attempting to download
the file. Please try again later.
An error occurred while creating the FC-MR threshold.
An error occurred while provisioning the internal
subnet: {0}
The port rate provisioning cannot be changed while
circuits exist on this port.
The port provisioning cannot be changed when the port
status is {0}.
Description
The absolute value entered was wrong.
CTC changed the incorrect parameter.
Refer to the error message text.
Refer to the error message text.
CTC could not complete the specified
action.
Refer to the error message text.
Refer to the error message text.
The Cisco Transport Controller (CTC)
was unable to validate the values
entered by the user, specified by {0}.
This error message is common to
several different provisioning tabs
within the CTC.
Refer to the error message text.
Refer to the warning message text.
CTC detected more than one
occurrence of the a DCC number.
Remove one of them.
Refer to the error message text.
You must create a Fibre Channel
Multirate (FC_MR) card threshold.
The specified internal subnet could not
be provisoned.
Refer to the error message text.
You must provision the ports only
when the port is Out of Service.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
Error Messages Reference
509