Cisco NCS 2000 series Troubleshooting Manual page 594

Hide thumbs Also See for NCS 2000 series:

Table of Contents

Error Messages Reference

Error/Warning

Cisco NCS 2000 series Troubleshooting Guide, Release 11.0

Error/Warning Message

You have only selected one trunk-to-OCH patchcord.

For complete deletion, you must select both patchcords

that are attached to the TXP/MXP card. Do you want

to continue?

OCHNC circuits, OSC terminations, synchronization

sources and protection groups must be removed before

you can remove this patchcord.

The Committed Info Rate value must be in range

The MTU value must be in range [64-9700].

The multicast IP address must be in range [224.0.0.0 -

239.255.255.255] Excluding the following IP address

subranges [(224-239).(0/128).0.(0-255)]

The multicast IP address count must be in range [1-256]

Could not retrieve TTY session for the chosen CRS.

CRS provisioning failed. {0}

The chosen node is not a CRS-1.

The value specified for IPv6 Address or IPv6 Default

Router is invalid.

The value specified for Prefix Length is invalid. Valid

range of values is 0 to 128.

IPv6 mode can be enabled only if SOCKS and firewall

are enabled on the node.

IPv6 mode cannot be enabled on a node if RIP is

IPv6 mode cannot be enabled on a node if 'OSPF on

LAN' is enabled.

IPv6 Address cannot be specified for {0} when IPv6

mode is not enabled on the node.

CTC was unable to delete SnmpV3 Target.

The card mode is invalid in this configuration.

SW version mismatch on node {0}: found {1}, expected

Error Messages

Refer to the warning message text.

Refer to the error message text.

Troubleshooting