Cisco NCS 2000 series Troubleshooting Manual page 571

Error Messages
Error/Warning
ID
WID-5065
WID-5066
WID-5067
EID-5068
EID-5069
EID-5070
EID-5071
EID-5072
EID-5073
EID-5074
EID-5075
EID-5076
EID-5077
EID-5078
EID-5079
EID-5080
EID-5081
Error/Warning Message
If you apply routing constraints to more than {0} nodes,
performance might be affected and the operation might
require more time than expected. Select Yes if you
intend to proceed in spite of this risk, or No if you
prefer to review your selection.
The routing constraints will be lost. Are you sure you
want to reset your changes?
The routing constraints will be lost. Are you sure you
want to leave this panel?
The routing constraints could not be applied.
A source node cannot be added to either of these lists.
A destination node cannot be added to either of these
lists.
This node already belongs to one of these lists.
An OCH-Trail tunnel link was found but without any
associated circuit.
You are creating an unprotected link from a protected
port. Do you want to continue?
Deleting OCH DCN circuits will cause a loss of
connectivity to nodes in the circuit path that do not have
other DCN connections. Do you want to continue?
The VLAN ID must be a number between 1 and 4093.
An error occurred while provisioning the VLAN ID.
The VLAN ID is already present in the current profile
An error occurred while provisioning the VLAN
database profile. {0}
The VLAN merge is not complete. You forgot to fill
{0} record(s).
An error occurred while validating the provisionable
patchcord.
No rolls are available.
An error occurred while tracing the RPR ring: {0}
Description
Refer to the warning message text.
Refer to the warning message text.
Refer to the warning message text.
Refer to the error message text.
Select a node other than the source
node to add to the route.
Select a node other than the
destination node to add to the route.
The node is already selected either in
include or exclude list in the OCH
circuit.
Create an OCH-Trail circuit associated
with the link.
Refer to the error message.
Refer to the error message.
Enter a number between 1 and 4093.
Select a VLAN ID that is not present
in the current profile.
CTC could not save the VLAN profile
to the file name mentioned.
Fill in the number of records specified
and then proceed.
Refer to the error message text.
You cannot delete a roll without
selecting a roll.
The circuit reference is invalid.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
Error Messages Reference
525