Cisco NCS 2000 series Troubleshooting Manual page 561

Error Messages
Error/Warning
ID
EID-3358
EID-3359
EID-3360
EID-3361
EID-3362
EID-3363
EID-3364
EID-3365
EID-3366
EID-3370
EID-3371
EID-3372
EID-3375
EID-3376
EID-3377
EID-3378
EID-3379
EID-3380
Error/Warning Message
An optical link model does not exist for the specified
interface.
Optical parameters could not be set for the node.
ANS cannot be performed. Please check {0} parameter
value.
The ring termination is in use. An error occurred while
deleting the ring termination.
An error occurred while deleting the ring termination.
No ring terminations were selected.
An error occurred while creating the ring ID.
The OSC termination is in use.
The OSC termination could not be deleted.
No optical link was selected.
An error occurred while calculating the automatic
optical link list.
CTC attempted to access an OCHNC connection that
has been destroyed.
The expected span loss must be set.
The measured span loss could not be retrieved.
The wrong interface was used.
This is a duplicate origination patchcord identifier.
This is a duplicate termination patchcord identifier.
The host cannot be found.
Description
Create an optical linkmodel for the
interface, and proceed.
Refer to the error message text.
Refer to the error message text.
You cannot delete a ring in use.
There was an error while deleting ring
termination.
You must select a ring termination.
There was an error while creating the
ring ID.
Select another optical service channel
(OSC) which is not in use.
There was an error deleting the OSC
termination.
You must select an optical link.
Refer to the error message text.
CTC destroyed an external attempt to
access an optical channel network
connection.
Refer to the error message text.
Refer to the error message text.
The interface used for the card is
wrong.
The provisionable patchcord identifier
to the patchcord you are attempting to
provision is already in use by another
patchcord on the origination node.
The provisionable patchcord identifier
to the patchcord you are attempting to
provision is already in use by another
patchcord on the remote node.
Refer to the error message text.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
Error Messages Reference
515