Cisco NCS 2000 series Troubleshooting Manual page 537

Error Messages
Error/Warning
ID
WID-2150
WID-2152
WID-2153
WID-2154
WID-2155
WID-2156
WID-2157
EID-2158
EID-2159
EID-2160
EID-2161
EID-2162
EID-2163
EID-2164
Error/Warning Message
The node {0} is not initialized. Please wait and try
again.
Spanning tree protection is being disabled for this
circuit.
Adding this drop will make the circuit a PCA circuit.
Monitor circuits cannot be created on a port grouping
circuit.
Switch counts might not be fully supported on some
nodes. {0}
The manual roll mode is recommended for dual rolls.
For auto dual rolls, please verify that roll to facilities
are in service and error-free.
The roll(s) cannot be completed. {0}
The roll mode is invalid. {0}
The roll is not ready for completion. {0}
The roll is not connected. {0}
The sibling roll is not complete. {0}
An error occurred during roll acknowledgement. {0}
The roll cannot be canceled. {0}
An error occurred during the roll. {0}
Description
Wait till the specified node is
initialized and try again.
Refer to the warning message text.
Refer to the warning message text.
Refer to the warning message text.
The specified nodes do not support
switch counts completely.
Refer to the warning message text.
CTC could not complete the roll
because the roll is destroyed, in an
incomplete state, in a TL1_roll state,
is cancelled, or is not ready to
complete.
There are two roll modes: auto and
manual. For a one-way circuit source
roll, the roll mode must be auto and
for a one- way circuit destination roll,
the roll mode must be manual.
The roll is not ready for completion.
Refer to error message text.
One of the rolls is not completed for
the dual roll. If it is auto roll, it will be
completed when a valid signal is
detected. If it is a manual roll, you
must complete the roll from CTC if
Bridge and Roll is operated from CTC,
or from TL1 if Bridge and Roll is
operated from TL1.
Refer to the error message text.
CTC cannot cancel the roll.
CTC encountered a roll error.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
Error Messages Reference
491