Ms-Deg - Cisco NCS 2000 series Troubleshooting Manual

Hide thumbs Also See for NCS 2000 series:

Table of Contents

Alarm Troubleshooting

If the condition does not clear, log into the Technical Support Website at

for more information or call Cisco TAC (1 800 553-2447).

MS-DEG

Default Severity:Not Alarmed (NA), Non-Service-Affecting (NSA)

Logical Object: STM1E

The Multiplex Section Signal Degrade condition is similar to the

but applies only to the multiplex section overhead of the EQPT object.

Clear the MS-DEG Condition

SUMMARY STEPS

1. Complete the

DETAILED STEPS

Complete the

Clear the SDBER-EXCEED-HO Condition, on page 389

If the condition does not clear, log into the Technical Support Website at

for more information or call Cisco TAC (1 800 553-2447).

Default Severity: Minor (MN), Non-Service-Affecting (NSA)

Logical Object: STMN

The MS-DCC Termination Failure alarm occurs when the system loses its data communications channel. The

DCC is nine bytes, D4 through D 12, in the SONET overhead. The bytes convey information about Operation,

Administration, Maintenance, and Provisioning (OAM&P). The system uses the DCC on the SONET section

overhead to communicate network management information.

Clear the MS-EOC Alarm

SUMMARY STEPS

1. Complete the

Clear the SDBER-EXCEED-HO Condition, on page 389

Clear the RS-EOC Alarm, on page 381

Cisco NCS 2000 series Troubleshooting Guide, Release 11.0

http://www.cisco.com/c/en/us/support/index.html

SDBER-EXCEED-HO , on page 388

http://www.cisco.com/c/en/us/support/index.html