Cisco NCS 2000 series Troubleshooting Manual page 576

Error Messages Reference
Error/Warning
ID
EID-5153
EID-5154
WID-5155
EID-5156
WID-5157
WID-5158
WID-5159
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
530
Error/Warning Message
Unable to perform SRLG synchronization operation.
Specified value is out of range for SRLG.
SRLG value should be specified between {0}-{1}
No. of SRLGs for circuit {0} are exceeding the limit.
One circuit can have maximum {1} SRLGs defined.
Trimming SRLG list to defined maximum size.
Maximum limit for defining additional SRLGs for
Node/Link is reached. Maximum SRLGs that can be
defined are {0}
No CRS based OCH Trail circuits detected
Some SRLGs cannot be deleted from CRS.
Please use Synchronize IPoDWDM to synchronize
SRLGs.
Some SRLGs cannot be set on CRS.
Please use Synchronize IPoDWDM to synchronize.
Error Messages
Description
• The node name/node IP address
or link source/link destination
information could not be
retrieved.
• Cisco CRS node connectivity is
down.
• XML interface on the Cisco CRS
is not reachable.
• Not enough memory on the Cisco
CRS.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
There are no Cisco CRS nodes
associated with the circuit.
• Cisco CRS node connectivity is
down.
• XML interface on the Cisco CRS
is not reachable.
• Not enough memory on the Cisco
CRS.
• Cisco CRS node connectivity is
down.
• XML interface on the Cisco CRS
is not reachable.
• Not enough memory on the Cisco
CRS.