Cisco NCS 2000 series Troubleshooting Manual page 33

C H A P T E R 3 Transient Conditions
Protection Switching, Lock Initiation, and Clearing
Initiate a 1+1 Protection Port Force Switch Command
Initiate a 1+1 Manual Switch Command
Initiate a 1:1 Card Switch Command
Clear a 1+1 Force or Manual Switch Command
Initiate a Lock-On Command
Initiate a Card or Port Lockout Command
Clear a Lock-On or Lockout Command
Initiate a Lockout on a BLSR Protect Span
Clear a BLSR External Switching Command
CTC Card Resetting and Switching
Reset a Card in CTC
Reset an Active Control Card and Activate the Standby Card
Physical Card Reseating, Resetting, and Replacement
Remove and Reinsert (Reseat) the Standby Control Card
Remove and Reinsert (Reseat) Any Card
Physically Replace a Card
Generic Signal and Circuit Procedures
Verify the Signal BER Threshold Level
Delete a Circuit
454
Verify or Create Node Section DCC Terminations
Clear an MXP, TXP, GE-XP, 10GE-XP, and ADM-10G Card Loopback Circuit
Verify or Create Node RS-DCC Terminations
Clear an STM-N Card XC Loopback Circuit
Air Filter and Fan Procedures
Inspect, Clean, and Replace the Reusable Air Filter
Remove and Reinsert a Fan-Tray Assembly
Replace the Fan-Tray Assembly
Interface Procedures
461
Replace the Alarm Interface Panel
465
Transients Indexed By Alphabetical Entry
Trouble Notifications
468
444
445
445
446
447
447
448
448
449
449
452
453
454
454
456
457
457
460
460
461
465
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
443
443
450
451
451
455
457
Contents
455
xxxiii