Cisco NCS 2000 series Troubleshooting Manual page 570

Error Messages Reference
Error/Warning
ID
WID-5051
EID-5052
EID-5053
EID-5054
EID-5055
EID-5056
EID-5057
EID-5058
EID-5059
EID-5060
EID-5061
EID-5062
WID-5063
EID-5064
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
524
Error/Warning Message
The port state cannot be indirectly transitioned because
the port aggregates OCHCC circuits: if the port state
needs to be changed, edit it directly through port
provisioning.
The operation is not valid for the connection type.
The operation cannot be performed because the
connection is under test access.
The TL1 tunnel could not be opened. {0}
Some patchcords were not deleted. Patchcords cannot
be deleted if they are incomplete or support any circuits,
or if the nodes supporting them are not connected.
This PPC cannot be deleted because one or more
circuits are provisioned over it.
The addition of the last node has not yet finished. Please
wait before trying to add a new node.
An OCHNC upgrade is applicable only to bidirectional
circuits.
The OCHNC upgrade failed. One or more
communication failures occurred during the operation.
The OCHNC upgrade partially failed. One or more
communication failures occurred during the operation.
Create the OCHCC manually.
The overhead circuit source and destination must reside
on the same shelf.
A four-fiber {0} cannot be created using three cards.
The profile "{0}" includes a change to the OPEN-SLOT
alarm severity. This change is disallowed for the ONS
15600. "{1}" will continue to use the OPEN-SLOT
severity of MN that is included in the default
configuration. Other changes from the "{2}" profile
were successfully applied to {3}".
{0}
{1}
Error Messages
Description
Refer to the warning message text.
You may have selected the incorrect
switch.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Remove the circuits provisioned over
the provisionable patchcord before
trying to delete it.
Refer to the error message text.
Refer to the error message text.
CTC encountered a complete failure
while upgrading optical channel
network connection.
CTC encountered a partial failure
while upgrading an optical channel
network connection.
Refer to the error message text.
A four-fiber BLSR needs four cards.
Refer to the warning message text.
This indicates the status of path
protection switching.