Cisco NCS 2000 series Troubleshooting Manual page 598

Hide thumbs Also See for NCS 2000 series:

Table of Contents

Error Messages Reference

Error/Warning

Cisco NCS 2000 series Troubleshooting Guide, Release 11.0

Error/Warning Message

Missing L2 internal patchcords between XP cards.

Profile cannot be mapped because the SVLAN is not

enabled on the port.

The configuration must be applied on the working

interface in case of protection group.

Squelch protection action and Auto mode are not

compatible in case of L2 1+1.

The NTP/SNTP server and the Backup NTP/SNTP

servers cannot be the same.

Multishelf VLAN range must be in range of {0} to {1}.

Changing the OTU2_XP card mode to 10GE LAN to

WAN will reboot the card.

Do you want to continue?

Changing the OTU2_XP card mode from 10GE LAN

to WAN will reboot the card and delete the pluggable

ports 1 and 3.

Do you want to continue?

The board is busy.

Please retry later.

The value "{0}" must be between {1} and {2}.

The value "{0}" has too many decimal points [xx.0 ..

The value "{0}" must be a float between {1} and {2}.

The value "{0}" must be a integer between {1} and

"{0}" is not a valid enumerated value.

Power fail low TCA is greater than high TCA.

Error while setting DISABLE FEC on {0}.

Error while setting STANDARD FEC on {0}.

Error while setting ENHANCED FEC on {0}.

Error while setting SD BER on {0}.

Error Messages

Refer to the error message text.

Troubleshooting