Cisco NCS 2000 series Troubleshooting Manual page 587

Error Messages
Error/Warning
ID
EID-6140
EID-6143
EID-6144
WID-6145
WID-6146
EID-6149
EID-6150
EID-6151
EID-6152
EID-6153
EID-6154
EID-6155
EID-6156
Error/Warning Message
The shelf identifier for a subtended shelf cannot be
provisioned through CTC. It must be changed using
the LCD.
The DHCP server could not be changed.
The port provisioning cannot be changed when the port
media is Undefined.
OSPF on LAN should only be enabled when the LAN
routers run OSPF. Otherwise, the node will not be
reachable from outside its subnet. RIP implementation
only advertise routes in one direction to connected
routers. It does not learn or distribute routes advertised
by other routers. Also note that enabling OSPF on the
LAN will temporarily cause the current list of static
routes to stop being advertised to remote nodes and
only be used locally.
Deleting the protection group while in a switched state
might cause a loss of traffic. It is recommended that
you verify switch states before proceeding.
The LAPD MTU size must be greater than or equal to
the {0} LSP buffer size {1}. Alternatively, you can
decrease the {0} LSP buffer size to {2}.
The value is out of range.
The minimum span loss must be less than the maximum
span loss.
The "Use NTP/SNTP Server" field is checked. Enter
the NTP/SNTP server IP address or server name.
The maximum frame size is invalid.
To combine unidirectional two-port provisioning and
autonegotiation on the same port, autonegotiation must
be set first.
Transponder mode cannot be provisioned with circuits
on the card.
The transponder configuration is invalid.
Description
Refer to the error message text.
Refer to the error message text.
If the port is not pre-provisioned with
the type of media that is going to be
inserted, you cannot access any of the
existing values for the port.
Refer to the warning message text.
Refer to the warning message text.
Refer to the error message text.
Enter a value that is within the range.
Refer to the error message text.
Enter the NTP/SNTP server name. To
leave this field empty, uncheck the
Use NTP/SNTP Server" and proceed.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
The transponder is not configured
properly.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
Error Messages Reference
541