Clear The Mfgmem Alarm - Cisco NCS 2000 series Troubleshooting Manual

Clear the MFGMEM Alarm

Clear the MFGMEM Alarm
SUMMARY STEPS
1. Soft reset the standby control card.
2. When the standby control card boots up, soft reset the active control card.
3. Reset the specific card on which the EEPROM has failed.
4. If the reset card has not rebooted successfully, or the alarm has not cleared, log into the Technical Support
Website at
800 553-2447).
DETAILED STEPS
Step 1
Soft reset the standby control card.
Step 2 When the standby control card boots up, soft reset the active control card.
Step 3
Reset the specific card on which the EEPROM has failed.
Step 4 If the reset card has not rebooted successfully, or the alarm has not cleared, log into the Technical Support Website at
http://www.cisco.com/c/en/us/support/index.html
MS-AIS
Default Severity: Not Reported (NR), Non-Service-Affecting (NSA)
Logical Object: STM1E, STMN
The Multiplex Section (MS) AIS condition indicates that there is a defect in the multiplexing section layer of
the SONET overhead. The multiplex section refers to the segment between two SONET devices in the circuit
and is also known as a maintenance span. The multiplex section layer of the SONET overhead deals with
payload transport, and its functions include multiplexing and synchronization.
Generally, any AIS is a special SONET signal that communicates to the receiving node when the transmit
node does not send a valid signal. AIS is not considered an error. It is raised by the receiving node on each
input when it detects the AIS instead of a real signal. In most cases when this condition is raised, an upstream
node is raising an alarm to indicate a signal failure; all nodes downstream from it only raise some type of AIS.
This condition clears when you resolved the problem on the upstream node.
Clear the MS-AIS Condition
SUMMARY STEPS
1. Complete the
DETAILED STEPS
Complete the Clear the AIS Condition, on page 116
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
306
http://www.cisco.com/c/en/us/support/index.html
for more information or call Cisco TAC (1 800 553-2447).
Clear the AIS Condition, on page 116
procedure.
for more information or call Cisco TAC (1
procedure.
Alarm Troubleshooting