Cisco NCS 2000 series Troubleshooting Manual page 600

Hide thumbs Also See for NCS 2000 series:
Table of Contents

Advertisement

Error Messages Reference
Error/Warning
ID
EID-6626
EID-6627
EID-6628
EID-6629
EID-6630
EID-6631
The following table lists the error messages for RAMAN-CTP, RAMAN-COP, EDRA-1-xx, and EDRA-2-xx
cards.
Error
Error RC01
Error RC02
Error RC03
Error RC04
Error RC05
Error RC06
Error RC07
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
554
Error/Warning Message
UNI Wrong Configuration.\n {0}
The operation is not supported
LAN WAN Enabled on the Port.
Operating mode is not provisioned on the PPM.
The FEC settings are incompatible.
Operation is not Supported. Valid License is not
available on Card/Peer Combination.
Error Message
Unexpected internal Error
Raman card is not plugged or not
ACTIVE
Raman pumps are not ON (either
OFF or APR)
Target Raman Gain/Tilt not set by
ANS
No reply received from facing node
(nodes communication error)
Cards in facing node are missing
or busy - in use by another
calibration or OTDR scan running
Raman Card is busy - in use by
another calibration (another side in
this node) or OTDR scan running
Error Messages
Description
Interface is already created or wrong
parameters configured.
Performing an unsupported operation.
LAN WAN is enabled on the Port.
The PPM does not have any mode
provisioned. Create a card mode for
the ports before creating the payload.
FEC mode is not configured correctly
for the protection mode being
provisioned during circuit creation.
Valid licence is not installed on the
peer card for the operation mode being
provisioned.
Cause/Solution
If the condition does not clear, log
into the Technical Support Website
at
http://www.cisco.com/c/en/us/
support/index.html
for more
information or call Cisco TAC (1
800 553-2447).
Ensure the Raman card is properly
plugged in and is active.
Check for fiber continuity and
connectors.
Ensure ANS parameters are
properly set by ANS.
The OSC PPP is down or there is
no communication between nodes.
Check if an OTDR scan is running
from either end of span or a Raman
calibration is under progress

Advertisement

Table of Contents
loading

Table of Contents