Volt-Mism - Cisco NCS 2000 series Troubleshooting Manual

VOLT-MISM

VOLT-MISM
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: PWR
The Power Monitoring Mismatch Between Control Cards alarm is raised against the shelf when the power
voltages of both the control cards are out of range of each other by more than 3V DC.
Clear the VOLT-MISM Condition
SUMMARY STEPS
1. Check the incoming voltage level to the shelf using a voltmeter. Follow site practices or refer to the Install
the Shelf and Common Control Cards chapter in the Configuration guide for power installation procedures.
2. Correct any incoming voltage issues.
DETAILED STEPS
Step 1 Check the incoming voltage level to the shelf using a voltmeter. Follow site practices or refer to the Install the Shelf and
Common Control Cards chapter in the Configuration guide for power installation procedures.
Step 2
Correct any incoming voltage issues.
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
WAITING-TO-START
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: OTS
The WAITING-TO-START condition is raised on the COM-TX and EXP-TX ports of 16-WXC-FS, 17 SMR9
FS, 24 SMR9 FS, 34 SMR9 FS, and SMR20 FS cards by the control cards when a cross-connection is ready
to start and/or waiting for other transient conditions to clear. The condition clears when cross-connection is
running in In-Service administrative state .
If the condition does not clear, log into the Technical Support Website at
index.html
WAN-SYNCLOSS
Default Severity: Major (MJ), Service-Affecting (SA)
Logical Objects: STSMON, STSTRM
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
434
for more information or call Cisco TAC (1 800 553-2447).
http://www.cisco.com/c/en/us/support/index.html
http://www.cisco.com/c/en/us/support/
Alarm Troubleshooting