Cisco NCS 2000 series Troubleshooting Manual page 569

Error Messages
Error/Warning
ID
EID-5037
EID-5038
EID-5039
EID-5040
EID-5041
EID-5042
WID-5043
EID-5044
EID-5045
WID-5046
EID-5047
EID-5048
EID-5049
EID-5050
Error/Warning Message
Provisionable patchcords cannot be created between
transponder trunk ports and multiplexer/demultiplexer
ports on the same node.
Provisionable patchcords created between transponder
trunk ports and multiplexer/demultiplexer ports must
use the same wavelength: {0} is not equal to {1}.
Provisionable patchcords created between transponder
trunk ports and multiplexer/demultiplexer ports must
use the same wavelength: {0} is not equal to {1}. Please
provision the {2} wavelength on {3}.
Provisionable patchcords created between OC3/OC12
ports and multiplexer/demultiplexer ports are not
supported.
Provisionable patchcords created between gray OC-N
trunk ports and multiplexer/demultiplexer ports are not
supported.
Provisionable patchcords created between OC-N trunk
ports and multiplexer/demultiplexer ports must use the
same wavelength: {0} is not equal to {1}.
Warning: Only the line card was provisioned. The
wavelength compatibility check was skipped.
Virtual links can be used only for OCH-Trail circuits.
The virtual link does not have wavelengths available.
Warning: if you select "Use OCHNC Direction," your
circuit will be limited to nodes prior to release 07.00.
Provisionable patchcords created between OC3/OC12
ports are not supported.
Provisionable patchcords created between gray OC-N
trunk ports are not supported.
Provisionable patchcords created between gray OC-N
trunk ports and multiplexer/demultiplexer ports are not
supported.
The element model could not be found. {0}
Description
You must create provisionable
patchcords between transponder trunk
ports and mux/demux ports that are on
different nodes.
Wavelengths used by provisionable
patchcords for transponder trunk ports
and mux/demux ports must be the
same.
Transmitter and receiver port
wavelengths are not equal. Provision
the receiver and transmitter
wavelengths on transmitter and
receiver ports respectively.
Refer to the error message text.
Refer to the error message text.
Wavelengths used by provisionable
patchcords for OC-N trunk ports and
mux/demux ports must be the same.
Refer to the warning message text.
Refer to the error message text.
Set wavelengths for the virtual link
and proceed.
Refer to the warning message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
The specified Element Model cannot
be located.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
Error Messages Reference
523