Peer-Noresponse - Cisco NCS 2000 series Troubleshooting Manual

Alarm Troubleshooting
DETAILED STEPS
Clear the Service-Affecting (SA) alarm at the remote data port.
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).

PEER-NORESPONSE

Default Severity: Major (MJ), Service-Affecting (SA)
Logical Object: EQPT
The switch agent raises a Peer Card Not Responding alarm if either traffic card in a protection group does not
receive a response to the peer status request message. PEER-NORESPONSE is a software failure and occurs
at the task level, as opposed to a communication failure, which is a hardware failure between peer cards.
Clear the PEER-NORESPONSE Alarm
SUMMARY STEPS
1. Complete the
2. Verify that the reset is complete and error-free and that no new related alarms appear in CTC. Verify the
LED appearance: A green ACT/SBY LED indicates an active card. An amber ACT/SBY LED indicates
a standby card.
DETAILED STEPS
Step 1
Complete the Reset a Card in CTC, on page 449
Step 2 Verify that the reset is complete and error-free and that no new related alarms appear in CTC. Verify the LED appearance:
A green ACT/SBY LED indicates an active card. An amber ACT/SBY LED indicates a standby card.
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
PMD-DEG
Default Severity: Major (MJ), Service-Affecting (SA)
Logical Object: Trunk port (dir RX)
The PMD Degrade alarm is raised when the device experiences PMD in excess of 11ps for 40ME-MXP-C
and 40-ME-TXP-C cards, 30ps for 40E-MXP-C and 40E-TXP-C cards, and 180ps for 100G-LC-C cards and
100G-ME-C cards.
Reset a Card in CTC, on page 449
procedure for the reporting card.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
http://www.cisco.com/c/en/us/support/index.html
procedure for the reporting card.
http://www.cisco.com/c/en/us/support/index.html
PEER-NORESPONSE
355