Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Cisco Manuals
  4. Network Hardware
  5. NCS 1004
  6. Quick start manual

Cisco NCS 1004 Series Quick Start Manual

Hide thumbs Also See for NCS 1004 Series:
1
2
3
4
5
6

Advertisement

Quick Links

Download this manual
Safety Guidelines
Before you perform any procedure in this publication, you must review the safety guidelines in this section
to avoid injuring yourself or damaging the equipment. Note that this section contains guidelines, and does
not include every potentially hazardous situation. During any installation procedure, always use caution and
common sense.
Review the complete list of safety warnings available at Regulatory Compliance and Safety Information for
Cisco NCS 1004 Series.
•
•
•
•
•
•
•
•
•

Standard Warning Statements

Warning
This unit is intended for installation in restricted access areas. A restricted access area can be accessed
only by using a special tool, lock and key, or other means of security.Statement 1017
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning
Hazardous voltage or energy may be present on power terminals. Always replace cover when terminals
are not in service. Be sure uninsulated conductors are not accessible when cover is in place. Statement
1086
Safety Guidelines
1

Advertisement

loading

Related Manuals for Cisco NCS 1004 Series

Summary of Contents for Cisco NCS 1004 Series

  • Page 1: Table Of Contents

    During any installation procedure, always use caution and common sense. Review the complete list of safety warnings available at Regulatory Compliance and Safety Information for Cisco NCS 1004 Series. • Standard Warning Statements, on page 1 •...

  • Page 2: General Safety Guidelines For Personal Safety And Equipment Protection

    • Do not wear loose clothing, jewelry (including rings and chains), or other items that could get caught in the equipment. • Fasten your tie or scarf and sleeves. • Operate Cisco equipment safely by using it in accordance with its electrical ratings and product usage instructions. • Do not work alone if potentially hazardous conditions exist.

  • Page 3: Safety With Electricity

    Safety Guidelines Safety with Electricity Safety with Electricity Warning Before working on a chassis or with power supplies, unplug the power cord on AC units. Disconnect the power at the circuit breaker on DC units.Statement 12 Warning Before working on equipment that is connected to power lines, remove jewelry (including rings, necklaces, and watches).

  • Page 4: Safety Precaution For Energy Hazard

    Do not reach into a vacant slot when installing or removing a module. Exposed circuitry is an energy hazard.Statement 206 The Cisco NCS 1004 can be configured for a DC power source. Do not touch terminals with body parts or conductive objects while they are energized.

  • Page 5: Prevent Electrostatic Discharge Damage

    Safety Guidelines Prevent Electrostatic Discharge Damage Figure 2: Class 1M Laser Product Label Warning Statement 291 Warning Invisible laser radiations present.Statement 1016 Warning Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams or view directly with optical instruments.Statement 1051 Prevent Electrostatic Discharge Damage Electrostatic discharge (ESD) can damage equipment and impair electrical circuitry.

  • Page 6: Nebs Regulatory Compliance Statements

    Safety Guidelines NEBS Regulatory Compliance Statements NEBS Regulatory Compliance Statements The NEBS-GR-1089-CORE regulatory compliance statements and requirements are discussed in this section. Warning The intra-building port(s) (Management Ethernet Ports) of the equipment or subassembly must use shielded intra-building cabling/wiring that is grounded at both ends. Statement 7003 Warning The intra-building port(s) (Management Ethernet Ports) of the equipment or subassembly is suitable for connection to intra-building or unexposed wiring or cabling only.