Cisco NCS 2000 series Troubleshooting Manual page 547

Error Messages
Error/Warning
ID
EID-3086
EID-3087
EID-3088
EID-3089
EID-3090
EID-3091
EID-3092
EID-3093
EID-3094
EID-3095
WID-3096
EID-3097
EID-3098
EID-3099
EID-3100
EID-3101
EID-3102
Error/Warning Message
One or more Osc terminations could not be created.
The OSC termination could not be edited.
No {0} card is present to switch.
The {0} state cannot be used or changed when the {1}
has failed or is missing.
The operation cannot be performed because the {0} is
{1}LOCKED_ON/LOCKED_OUT.
The operation cannot be performed because the protect
card is active.
The requested action cannot be applied because the
service state is invalid.
The operation cannot be performed because the duplex
pair is {0}locked.
The operation cannot be performed because no
cross-connect redundancy is available.
The deletion failed because the circuit is in use
An internal communication error was encountered while
retrieving laser parameters. This can happen when
equipment is not present or when equipment is resetting.
Check the equipment state and try to refresh the values
again.
The ring termination is in use.
No ring terminations were selected.
The entered key does not match the existing
authentication key.
An error occurred during authentication.
The DCC metric must be between 1 and 65535.
The DCC metric is invalid.
Description
Refer to the error message text.
Refer to the error message text.
No card of the specified type is
available to switch.
You cannot use or change the
specified state when the card is failed
or missing.
You cannot perform operation.
Refer to the error message text.
Select another service state and
proceed.
Refer to the error message text.
You cannot perform the requested
operation on the cross connect card
without having a backup cross connect
card.
Refer to the error message text.
Refer to the warning message text.
The ring termination you are trying to
access is in use. Try after sometime.
Select one of the ring terminations.
Check the authentication key and
reenter.
There was an error in authentication.
Verify that the key does not exceed
the character limit.
The DCC metric should be in the
range of 1 to 65535.
There was an invalid DCC metric.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
Error Messages Reference
501