Cisco NCS 2000 series Troubleshooting Manual page 572

Error Messages Reference
Error/Warning
ID
EID-5082
EID-5083
EID-5084
EID-5085
EID-5086
EID-5087
EID-5088
WID-5089
EID-5090
EID-5091
WID-5092
EID-5094
EID-5095
EID-5096
EID-5097
EID-5098
EID-5099
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
526
Error/Warning Message
{0} does not support: - Low-order circuits that have
both {1}-protected and {2}-protected spans and that
cross a node that does not have low-order cross-connect
capability. - High-order circuits that carry low-order
circuits with the parameters described above.
This circuit is not the same size as the existing circuit
{0}. This circuit has size {1} and the existing circuit
has size {2}.
The Trunk model could not be found. {0}
The maximum number of VLAN DB profiles is {0}.
The circuit roll failed. You cannot bridge and roll the
selected circuit because it has a monitor circuit.
You cannot use same slot for east working and west
protect ports.
You cannot use same slot for east working and west
protect ports.
The maximum number of circuits that can be deleted
at a time is 200. Do you want to delete the first 200
circuits selected?
This operation cannot be completed. The selected
circuits have different state models; please select
circuits of the same type.
Some PPC terminations were not repaired.
The TL1 encoding mode for the tunnel is being
changed. Do you want to modify the encoding?
Currently, CTC does not support bridge and roll on
circuits having multiple cross-connects on a single node.
No path were selected. Please select at least one path
starting from the {0} NE.
The first path must starts from the {0} NE.
The selected path should be linked with the last selected
and keep the same direction.
The node is not selectable. Only the Span between the
nodes are selectable.
Raman Command Error on {0}. {1}.
Error Messages
Description
Refer to the error message text.
During an RPR circuit creation ML
card, the new circuit size and the
existing circuit size must be the same.
The trunk specified is not found.
Refer to the error message.
Refer to the error message.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text
Refer to the error message text
Refer to the error message text
Confirm if you really want to modify
TL1 tunnel encoding.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.