Clear The Local-Fault Alarm - Cisco NCS 2000 series Troubleshooting Manual

Clear the LOCAL-FAULT Alarm

Clear the LOCAL-FAULT Alarm
SUMMARY STEPS
1. Verify and resolve the loss of signal on the port where the alarm is raised.
DETAILED STEPS
Verify and resolve the loss of signal on the port where the alarm is raised.
If the alarm does not get cleared, you need to report a Service-Affecting (SA) problem. Log into the Technical Support
Website at http://www.cisco.com/c/en/us/support/index.html
en/us/support/web/tsd-cisco-worldwide-contacts.html
your country.
LOCKOUT-REQ
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Objects: 2R, EQPT, ESCON, FC, GE, ISC, OTS, TRUNK
The Lockout Switch Request on Facility or Equipment condition occurs when a user initiates a lockout switch
request for an OC-N port in a 1+1 facility protection group. This can be accomplished by locking traffic onto
the working port with the LOCK ON command (thus locking it off the protect port), or locking it off the
protect port with the LOCK OUT command. In either case, the protect port will show Lockout of Protection,
and the Conditions window will show the LOCKOUT-REQ condition.
A lockout prevents protection switching. Clearing the lockout again allows protection switching and clears
the LOCKOUT-REQ condition.
Clear the LOCKOUT-REQ Condition
SUMMARY STEPS
1. Complete the
DETAILED STEPS
Complete the Clear a Lock-On or Lockout Command, on page 447
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
262
to obtain a directory of toll-free Technical Support numbers for
Clear a Lock-On or Lockout Command, on page 447
for more information or log into
procedure.
procedure.
http://www.cisco.com/c/en/us/support/index.html
Alarm Troubleshooting
http://www.cisco.com/c/