Optntwmis - Cisco NCS 2000 series Troubleshooting Manual

OPTNTWMIS

DETAILED STEPS
Use filler cards to fill the empty slots. Blank cards are not detected by the software. For more details about the filler cards,
see the Cisco NCS 2000 Series Hardware Installation Guide.
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
OPTNTWMIS
Default Severity: Major (MJ), Non-Service-Affecting (NSA)
Logical Object: NE
The Optical Network Type Mismatch alarm is raised when DWDM nodes are not configured for the same
type of network, either MetroCore or MetroAccess. All DWDM nodes on the same network must be configured
for the same network type because APC and ANS behave differently on each of these network types. For
more information about APC and ANS, refer to the Network Reference chapter in the Configuration guide.
When the OPTNTWMIS alarm occurs, the
Clear the OPTNTWMIS Alarm
SUMMARY STEPS
1. In node view (single-shelf mode) or multishelf view (multishelf mode) of the alarmed node, click the
Provisioning > WDM-ANS > Provisioning tabs.
2. Choose the correct option from the Network Type list box, and click Apply.
DETAILED STEPS
Step 1 In node view (single-shelf mode) or multishelf view (multishelf mode) of the alarmed node, click the Provisioning >
WDM-ANS > Provisioning tabs.
Step 2 Choose the correct option from the Network Type list box, and click Apply.
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
OPWR-HDEG
Default Severity: Minor (MN), Non-Service-Affecting (NSA)
Logical Objects: AOTS, OCH, OCH-TERM, OMS, OTS
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
322
http://www.cisco.com/c/en/us/support/index.html
APC-DISABLED , on page 119
http://www.cisco.com/c/en/us/support/index.html
Alarm Troubleshooting
alarm could also be raised.