Cisco NCS 2000 series Troubleshooting Manual page 566

Error Messages Reference
Error/Warning
ID
EID-4036
EID-4037
EID-4051
EID-4052
EID-5000
EID-5001
EID-5002
EID-5003
EID-5004
WID-5005
WID-5006
WID-5007
WID-5008
WID-5009
EID-5010
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
520
Error/Warning Message
WDMANS parameter cannot be removed.
This may be in use by the system.
This operation is not supported on the protect entity of
a protection group.
The bandwidth for the configuration modes is allocated
once the payload for the PPMs are provisioned.
In case of MXP_MR mode the bandwidth is allocated
only after a circuit is created.
ODU Utilization is not supported for this mode.
Bandwidth utilization is not valid for Operating mode
provisioned on the PPM.
A valid route cannot be found for the tunnel change
request.
The tunnel could not be changed.
The tunnel could not be restored and must be recreated
manually.
The circuit roll failed. {0}
There is already one four-fiber {0} provisioned on the
set of nodes involved in {1}. The maximum number of
four-fiber {0} rings has been reached for that node.
A non-zero hold-off time can violate switching time
standards, and should only be used for a circuit with
multiple path selectors.
Warning: A different secondary {0} node should only
be used for DRI or open-ended path protected circuits.
If you change the scope of this view, the contents of
this profile editor will be lost.
Please ensure that all the protection groups are in proper
states after the cancellation.
The circuit {0} is not upgradable. No {1} capable {2}s
are available at the node {3}.
The domain name already exists.
Error Messages
Description
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
There is already one 4F BLSR
provisioned on the set of nodes
involved in the ring. The maximum
number of 4F BLSR rings has been
reached for that node.
Refer to the warning message text.
You should use different secondary
end point only for DRI or open-ended
path protected circuits.
Refer to the warning message text.
Refer to the warning message text.
No VT capable STSs are available at
the node.
Refer to the error message text.