Cisco NCS 2000 series Troubleshooting Manual page 581

Error Messages
Error/Warning
ID
EID-6029
EID-6030
EID-6031
EID-6032
EID-6033
EID-6035
EID-6036
EID-6037
EID-6038
EID-6039
EID-6040
EID-6041
EID-6042
EID-6043
EID-6044
EID-6045
EID-6046
EID-6047
EID-6048
EID-6049
Error/Warning Message
The next hop of a static route cannot be the same as the
destination of the route or an internal network{0}.
The next hop of a static default route must be the
provisioned default router.
No more static routes can be created.
This static route already exists.
A previous operation is still in progress.
The parent entity does not exist.
The parent PPM entity does not exist.
This equipment type is not supported.
The PPM port is invalid.
The card is part of a regeneration group.
Out of memory.
The port is already present.
The port is used as timing source.
A DCC or GCC is present.
The card or port is part of protection group.
The port has overhead circuit(s).
The ITU-T G.709 configuration is not compatible with
the data rate.
The port cannot be deleted because its service state is
OOS-MA,LPBK&MT.
{0} is {1}.
The card operating mode of {0} is not supported.
Description
Static route must have the default
route as the next hop, and not
destination of the route or internal
network.
The default route is selected for
networks that do not have a specific
route.
You have reached the maximum
number of static routes.
Refer to the error message text.
Another operation is in progress. You
must try after sometime.
Refer to the error message text.
Create a parent entity for the PPM.
CTC does not support this equipment.
Refer to the error message text.
Select another card.
Refer to the error message text.
Refer to the error message text.
Choose another port because the
selected port is being used as a timing
source.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
To delete the port, you must change
the port state to OOS-DSBLD.
The trunk port is in the wrong state to
carry out the action.
CTC does not support the mode of
operation requested on the card.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
Error Messages Reference
535