Sysboot - Cisco NCS 2000 series Troubleshooting Manual

Alarm Troubleshooting
4. If the third timing source is an incoming port on the system, complete the Clear the LOS (OCN/STMN)
Alarm procedure located in the Alarm Troubleshooting chapter of the Troubleshooting guide.
5.
DETAILED STEPS
Step 1 In node view (single-shelf mode) or shelf view (multishelf mode), click the Provisioning > Timing > General tabs.
Step 2
Verify that the current configuration of REF-3 for the NE Reference. For more information about references, refer to the
Timing chapter in the Configuration guide.
Step 3 If the third timing source is a BITS input, complete the
Step 4
If the third timing source is an incoming port on the system, complete the Clear the LOS (OCN/STMN) Alarm procedure
located in the Alarm Troubleshooting chapter of the Troubleshooting guide.
Always use the supplied electrostatic discharge wristband when working with a powered system. Plug the
Caution
wristband cable into the ESD jack located on the lower-right edge of the shelf assembly.
Step 5
Wait ten minutes to verify that the control card you reset completely reboots and becomes the standby card.
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).

SYSBOOT

Default Severity: Major (MJ), Service-Affecting (SA)
Logical Object: NE
The System Reboot alarm indicates that new software is booting on the control card. No action is required to
clear the alarm. The alarm clears when all cards finish rebooting the new software. The reboot takes up to 30
minutes. However, if several line cards are present on the nodes in the network or if the line cards reboot
many times, the alarm clears before all the line cards reboot completely.
If the condition does not clear, log into the Technical Support Website at
index.html
Note SYSBOOT is an informational alarm. It only requires troubleshooting if it does not clear.
TEMP-LIC
Default Severity: Minor (MN), Non-Service-Affecting (NSA)
Logical Object: EQPT
The Temporary License (TEMP-LIC) alarm is raised to indicate that a valid temporary license is in use.
for more information or call Cisco TAC (1 800 553-2447).
Clear the LOS (BITS) Alarm, on page 274
http://www.cisco.com/c/en/us/support/index.html
http://www.cisco.com/c/en/us/support/
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
SYSBOOT
procedure.
413