Cisco NCS 2000 series Troubleshooting Manual page 592

Error Messages Reference
Error/Warning
ID
EID-6273
EID-6274
EID-6275
EID-6276
EID-6277
EID-6278
EID-6279
WID-6280
EID-6281
WID-6282
WID-6283
WID-6284
WID-6285
EID-6286
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
546
Error/Warning Message
An OCH Trail circuit is active on the trunk port. To
modify the ITU-T G.709 parameter, the circuit must
be out of service.
Unable to restore this database: The software version
cannot be obtained from the node. Please try again.
You cannot change this parameter. The port is part of
an active circuit.
APC is disabled. APC Correction Skipped. Override
cannot be performed.
There are no alarm conditions available to run APC
Correction Skipped Override.
APC Correction Skipped Override is not supported for
this card.
Protection cannot be disabled when the FPAS alarm is
active.
Any configuration change will be lost and the operation
is traffic affecting.
The port is involved in a protection group. The
protected port is not in the {0} administrative state
Forcing FPGA update will be traffic-affecting.
Enabling ALS on a DWDM trunk port that is connected
to a channel filter will result in a conflict with the ALS
on the amplifier card or with the VOA startup process.
Is it OK to continue?
Changing the timing standard will re-initialize the shelf
timing and might affect traffic. OK to continue?
Since you are changing the IP address of one node
containing some PPC terminations, you are also
requested to run the PPC Repair tool in order to fix the
IP addresses stored in the nodes connected by these
PPCs
The port type cannot be changed because the port has
been deleted.
Error Messages
Description
Refer to the error message text.
The user tries to restore a database on
a node, but its not possible to get the
software version from it.
Certain parameters like Port Rate and
Admin State cannot be changed when
the port is part is part of an active
circuit. Delete all the circuits on the
port before changing admin state of
the port.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Change the port state to
administrative.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.