Cisco NCS 2000 series Troubleshooting Manual page 543

Error Messages
Error/Warning
ID
EID-3002
EID-3003
EID-3004
EID-3005
EID-3006
EID-3007
EID-3008
EID-3009
EID-3010
EID-3016
EID-3017
EID-3019
EID-3020
EID-3021
EID-3022
EID-3023
EID-3024
Error/Warning Message
An error occurred while retrieving defaults from the
node: {0}
The file {0} cannot be loaded.
Properties cannot be loaded from the node.
NE update properties cannot be saved to the file {0}.
NE update properties cannot be loaded from the node.
An error occurred while provisioning the {0}.
This is not a valid card.
No {0} was selected.
A bidirectional optical link could not be created.
The subnet address is invalid.
The subnet address already exists.
The internal subnet address is incomplete.
The subnet address cannot be the same for both TSC
cards. The requested action is not allowed.
An error occurred while retrieving the diagnostics: {0}
The requested action is not allowed.
The low order cross-connect mode could not be
retrieved.
The {0} cross-connect mode could not be switched.
Please verify that the type and/or number of circuits
provisioned does not exceed the criterion for switching
modes.
Description
There was an error while retrieving
the defaults from the specified node.
CTC cannot load the specified file.
Refer to the error message text.
CTC cannot save the network element
(NE) update values to the specified
file.
Refer to the error message text.
There was a provisioning error for the
specified item.
You cannot perform DWDM
automatic node setup (ANS) from the
Card view. Please navigate to the
Node view and try again.
Select the specified item, for example,
VLAN, port, slot, etc.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Enter the complete internal subnet
address.
A node internal subnet must be
different from one another as each
TSC is on separate ethernet buses,
isolated by broadcast domains.
Refer to the error message text.
The requested action is not allowed.
Refer to the error message text.
CTC cannot switch the cross-connect
mode for the specified item, as the
type or the number of circuits does not
match with the criterion for switching
modes.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
Error Messages Reference
497