Autosw-Uneq-Sncp (Vcmon-Hp) - Cisco NCS 2000 series Troubleshooting Manual

Alarm Troubleshooting

AUTOSW-UNEQ-SNCP (VCMON-HP)

Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: VCMON-HP
The Automatic UPSR Switch Caused by an Unequipped condition indicates that an HP-UNEQ alarm caused
automatic UPSR protection switching to occur (see the
for revertive switching, it reverts to the working path after the fault clears.
Warning Class 1 laser product. Statement 1008
Warning Class 1M laser radiation when open. Do not view directly with optical instruments. Statement 1053
Warning
Invisible laser radiation could be emitted from the end of the unterminated fiber cable or connector.
Do not stare into the beam directly with optical instruments. Viewing the laser output with certain
optical instruments (for example, eye loupes, magnifiers, and microscopes) within a distance of 100 mm
could pose an eye hazard. Statement 1056
Warning Use of controls, adjustments, or performing procedures other than those specified could result in
hazardous radiation exposure. Statement 1057
Note This condition is only reported if the SNCP is set up for revertive switching.
Clear the AUTOSW-UNEQ-SNCP (VCMON-HP) Condition
SUMMARY STEPS
1. Complete the
DETAILED STEPS
Complete the Clear the HP-UNEQ Alarm, on page 232
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
Clear the HP-UNEQ Alarm, on page 232
procedure.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
AUTOSW-UNEQ-SNCP (VCMON-HP)
HP-UNEQ , on page 232). If the UPSR ring is configured
procedure.
http://www.cisco.com/c/en/us/support/index.html
141