Cisco NCS 2000 series Troubleshooting Manual page 556

Error Messages Reference
Error/Warning
ID
WID-3263
EID-3265
EID-3266
WID-3267
WID-3268
WID-3269
WID-3270
WID-3271
WID-3272
WID-3273
WID-3274
WID-3275
WID-3276
WID-3277
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
510
Error/Warning Message
You are using Java version {0}. CTC should run with
Java version {1}. It can be obtained from the installation
CD or http://java.sun.com/j2se/
An error occurred while modifying the protection group.
Conditions could not be retrieved from the shelf or card
view.
The XTC protection group cannot be modified.
The filter entry is invalid. {0}
The {0} operation was successfully initiated for {1}
but its completion status could not be obtained from
the node. When the node is accessible, check its
software version to verify if the {0} succeeded.
The file {0} does not exist.
The value entered must be greater than {0}.
An entry is required.
{0} already exists in the list.
A software upgrade is in progress. Network
configuration changes that result in a node reboot
cannot take place during a software upgrade. Please try
again after the software upgrade is done.
Ensure that the remote interface ID and the local
interface ID on the two sides match. (The local interface
ID on this node should equal the remote interface ID
on the neighbor node and vice-versa).
Both {0} and {1} exist on the same selected port. {2}
The description cannot exceed {0} characters. Your
input will be truncated.
Error Messages
Description
CTC is being launched with the wrong
version of the JRE {0}. This version
of CTC requires a particular version
of the JRE {1}. The CTC and browser
must be closed and restarted to allow
the correct Java version to be loaded.
Protection Group could not be
modified.
Refer to the error message text.
Refer to the warning message text.
The specified entry is invalid.
Refer to the error message text.
The specified file does not exist.
The value entered must be greater than
the specified value.
An entry is required to complete this
task.
The specified item already exists in
the list.
Refer to the warning message text.
Refer to the warning message text.
The specified port has both SDCC and
LDCC.
The input exceeds the character limit.
The value will be truncated to the
maximum character limit.