Cisco NCS 2000 series Troubleshooting Manual page 539

Error Messages
Error/Warning
ID
EID-2180
EID-2181
EID-2182
EID-2183
EID-2184
EID-2185
EID-2186
EID-2187
EID-2188
EID-2189
EID-2190
EID-2191
EID-2192
EID-2193
Error/Warning Message
The CTC initialization failed during step {0}.
This link cannot be included because it originates from
the destination.
The value of {0} is invalid.
The circuit roll failed. Bridge and roll is not supported
on VCAT circuits.
Spanning Tree Protocol cannot be enabled on some
ports because the ports have been assigned an
incompatible list of VLANs. You can view the
VLAN/Spanning Tree table or reassign the Ethernet
port VLANs.
The VLANs on some ports cannot be assigned because
they are incompatible with the Spanning Tree Protocol.
You can view the VLAN/Spanning Tree table or
reassign the VLANs.
The software download failed on node {0}.
The ring name cannot exceed {0} characters. Please
try again.
The nodes in this ring do not support alphanumeric IDs.
Please use a ring ID between {0} and {1}.
The TL1 keyword "all" cannot be used as the ring name.
Please provide another name.
Adding this span will cause the ring to contain more
nodes than allowed.
The ring name must not be empty.
A valid route cannot be found for the circuit creation
request.
A valid route cannot be found for the circuit drop
creation request.
Description
CTC initialization has failed in the
specified step.
You must not include this link as it
originates from destination of a circuit.
It is against the path selection
algorithm.
The value of the specified item is
invalid.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
The software could not be downloaded
onto the specified node.
You must shorten the length of the
ring name.
The ring ID should not contain
alphanumeric characters, and must be
in the specified range.
Refer to the error message text.
You have reached the maximum
number of nodes allowed.
You must supply a ring name.
CTC could not complete the circuit
creation request either because there
are no physical links, or the bandwidth
of the available links are already
reserved.
Refer to the error message text.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
Error Messages Reference
493