Cisco NCS 2000 series Troubleshooting Manual page 558

Error Messages Reference
Error/Warning
ID
EID-3294
EID-3295
EID-3296
EID-3298
EID-3300
EID-3301
EID-3302
EID-3303
EID-3304
EID-3305
EID-3306
EID-3307
EID-3308
EID-3309
EID-3310
EID-3311
EID-3312
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
512
Error/Warning Message
No RMON thresholds are available for the selected
port.
This card does not support RMON thresholds.
Buffer-to-buffer credit is only supported for Fibre
Channel (FC) and FICON.
This interfaces does not support ALS auto restart.
Duplicate OSPF area IDs are not permitted.
The LAN metric cannot be zero.
The standby {0} is not ready.
The DCC area ID and {0} conflict. {1}
The DCC number is out of range.
OSPF cannot be active on the LAN interface when the
backbone area is set on a DCC interface.
Ethernet circuits must be bidirectional.
An error occurred while creating a connection object
at {0}.
DWDM links can be used only for optical channel
circuits.
The link was excluded because it was in the wrong
direction.
The DWDM link does not have wavelengths available.
The laser is already on.
The power setpoint cannot be changed. {0} {1}
Error Messages
Description
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
OSPF area IDs should be unique.
Refer to the error message text.
Standby controller card is not ready.
DCC Area ID and ring type, specified
by {0}, conflict each other due to the
details specified by {1}.
Enter a DCC number that is within the
range
You cannot have the default OSPF
area on a DCC while OSPF is enabled
on the LAN.
Refer to the error message text.
CTC encountered an error at the
specified connection while creating
the connection.
Refer to the error message text.
The optical channel (circuit) does not
allow the specified link to be included
because it is in the wrong optical
direction.
Refer to the error message text.
Refer to the error message text.
CTC cannot change the power
setpoint. The new setpoint would
either make the thresholds inconsistent
or set the fail threshold outside the
range.