Clear The Rfi Condition - Cisco NCS 2000 series Troubleshooting Manual

Alarm Troubleshooting

Clear the RFI Condition

SUMMARY STEPS
1. Complete the
DETAILED STEPS
Complete the Delete a Circuit, on page 454
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
RFI-L
Default Severity: Not Reported (NR), Non-Service-Affecting (NSA)
Logical Object: TRUNK
A RFI Line condition occurs when the system detects an RFI in OC-N card SONET overhead because of a
fault in another node. Resolving the fault in the adjoining node clears the RFI-L condition in the reporting
node. RFI-L indicates that the condition is occurring at the line level.
Clear the RFI-L Condition
SUMMARY STEPS
1. Log into the node at the far-end node of the reporting system.
2. Identify and clear any alarms, particularly the LOS (OCN) alarm.
DETAILED STEPS
Step 1
Log into the node at the far-end node of the reporting system.
Step 2 Identify and clear any alarms, particularly the LOS (OCN) alarm.
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
RFI-P
Default Severity: Not Reported (NR), Non-Service-Affecting (NSA)
Logical Object: STSMON, STSTRM
Delete a Circuit, on page 454
procedure and then recreate the circuit.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
procedure and then recreate the circuit.
http://www.cisco.com/c/en/us/support/index.html
http://www.cisco.com/c/en/us/support/index.html
Clear the RFI Condition
377