Au-Ais; Clear The Au-Ais Condition; Aud-Log-Loss; Clear The Aud-Log-Loss Condition - Cisco ONS 15600 SDH Troubleshooting Manual

Chapter 2 Alarm Troubleshooting
Complete the
Step 6
lockout.
Step 7 If the alarm does not clear, log into the Technical Support Website at http://www.cisco.com/techsupport
for more information or call Cisco TAC (1 800 553-2447) to report a Service-Affecting (SA) problem.

2.6.9 AU-AIS

An AU AIS condition applies to the administration unit, which consists of the virtual container (VC)
capacity and pointer bytes (H1, H2, and H3) in the SDH frame.
Generally, any AIS is a special SDH signal that communicates to the receiving node when the transmit
node does not send a valid signal. AIS is not considered an error. It is raised by the receiving node on
each input when it detects the AIS instead of a real signal. In most cases when this condition is raised,
an upstream node is raising an alarm to indicate a signal failure; all nodes downstream from it only raise
some type of AIS. This condition clears when you resolved the problem on the upstream node.

Clear the AU-AIS Condition

Step 1 Complete the
If the condition does not clear, complete the
Step 2
If the condition does not clear, log into the Technical Support Website at
Step 3
http://www.cisco.com/techsupport for more information or log into
http://www.cisco.com/warp/public/687/Directory/DirTAC.shtml to obtain a directory of toll-free
Technical Support numbers for your country.

2.6.10 AUD-LOG-LOSS

The Audit Trail Log Loss condition occurs when the log is 100 percent full and that the oldest entries
are being replaced as new entries are generated. The log capacity is 640 entries. The log must be
off-loaded using the following procedure to make room for more entries.

Clear the AUD-LOG-LOSS Condition

In node view, click the Maintenance > Audit tabs.
Step 1
Click Retrieve.
Step 2
Click Archive.
Step 3
July 2010
"Clear a MS-SPRing External Switching Command" procedure on page 2-130
Default Severity: Not Reported (NR), Non-Service-Affecting (NSA)
Logical Objects: VCMON-HP
"Clear the AIS Condition" procedure on page
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: NE
2-15.
"Clear the APSB Alarm" procedure on page
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
2.6.9 AU-AIS
to clear the
2-16.
2-21