Hi-Rxtemp - Cisco NCS 2000 series Troubleshooting Manual

Alarm Troubleshooting

HI-RXTEMP

Default Severity: Minor (MN), Non-Service-Affecting (NSA)
Logical Objects: TRUNK
The Equipment High Receive temperature alarm refers to the temperature of the trunk card port for the TXP
and MXP cards. The HI-RXTEMP threshold is user-provisionable.
Clear the HI-RXTEMP Alarm
SUMMARY STEPS
1. If a shelf HITEMP alarm is also present, complete the
2. If a HI-LASERTEMP alarm is also present, complete the
3. If the alarm does not clear, log onto http://www.cisco.com/tac for more information or call TAC
(1-800-553-2447).
DETAILED STEPS
Step 1 If a shelf HITEMP alarm is also present, complete the
Step 2
If a HI-LASERTEMP alarm is also present, complete the
Note If no data alarms have occurred, the card does not need to be replaced immediately.
Step 3 If the alarm does not clear, log onto http://www.cisco.com/tac for more information or call TAC (1-800-553-2447).
HI-TXPOWER
Default Severity: Minor (MN), Non-Service-Affecting (NSA)
Logical Objects: 2R, EQPT, ESCON, FC, GE, ISC, OCN/STMN, PPM, TRUNK
The Equipment High Transmit Power alarm is an indicator on the TXP_MR_E, TXP_MR_10G,
TXP_MR_2.5G, TXPP_MR_2.5G, MXP_2.5G_10G, OC192-XFP, ADM-10G, or OTU2_XP card transmitted
optical signal power. HI-TXPOWER occurs when the measured optical power of the transmitted signal exceeds
the threshold.
Clear the HI-TXPOWER Alarm
SUMMARY STEPS
1. Check the PM of the Trunk-Tx port. Verify that received power is above the optics threshold:
2. Physically verify, by using a standard power meter that the optical output power is overcoming the expected
power threshold. If so, the card should be replaced at first opportunity
3. Complete the
Clear the HITEMP
Physically Replace a Card, on page 453
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
Clear the HITEMP
Clear the HI-LASERTEMP Alarm
Alarm.
Clear the HI-LASERTEMP Alarm
procedure.
HI-RXTEMP
Alarm.
.
.
225