Cisco NCS 2000 series Troubleshooting Manual page 554

Error Messages Reference
Error/Warning
ID
EID-3233
EID-3234
EID-3235
EID-3236
EID-3237
EID-3238
EID-3239
EID-3240
EID-3241
EID-3242
WID-3243
EID-3244
WID-3245
EID-3246
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
508
Error/Warning Message
The current loopback provisioning does not allow this
state transition.
The current synchronization provisioning does not allow
this state transition.
The requested state transition cannot be performed on
this software version.
The database restore failed. {0}
The database backup failed. {0}
The send PDIP setting on {0} is inconsistent with the
setting on the control node {1}.
The overhead termination is invalid
The maximum number of overhead terminations has
been exceeded.
The {0} termination port is in use.
An {1} exists on the selected ports. Therefore, you must
create the {0}s one by one.
The port you have chosen as an {0} endpoint already
supports an {1}. The port cannot support both DCCs.
After the {0} is created, verify that no EOC alarms are
present and then delete the {1} to complete the
downgrade.
An {0} exists on the selected ports. Therefore, you must
create the {1}s one by one.
The port you have chosen as an {1} endpoint already
supports an {0}. The port cannot support both DCCs.
After the {1} is created, verify that no EOC alarms are
present and then delete the {0} to complete the upgrade.
The wizard was not able to validate the data. {0}
Error Messages
Description
Refer to the error message text.
You cannot transition the port state to
the target date while in the current
synchronization state.
Refer to the error message text.
CTC failed to restore the specified
database.
CTC failed to backup the specified
database.
The send payload defect indicator path
(PDI-P) setting on the specified item
should be consistent with that of the
specified control node.
Refer to the error message text.
Overhead terminations have exceeded
the limit.
The specified termination port is in
use. Select another port.
The specified DCC already exists on
the selected port. You can create a
DCC of another type.
The same port can not be used by
multiple DCCs.
The specified DCC already exists on
the selected port. You can create a
DCC of another type.
The port selected as a DCC endpoint
already supports another DCC. Refer
to the warning message text.
CTC encountered an error.