Cisco NCS 2000 series Troubleshooting Manual page 549

Error Messages
Error/Warning
ID
EID-3122
EID-3123
EID-3124
EID-3125
EID-3126
EID-3127
EID-3128
EID-3129
EID-3130
EID-3131
EID-3132
EID-3133
EID-3134
EID-3135
EID-3136
EID-3137
EID-3138
EID-3139
Error/Warning Message
No object of type {0} was selected to edit.
An error occurred while editing {0}.
The {0} termination is in use. Delete the associated
OSPF range table entry and try again.
No {0} terminations were selected.
The {0} termination could not be edited.
Orderwire cannot be provisioned because the E2 byte
is in use by {0}.
The authentication key cannot exceed {0} characters.
The authentication keys do not match!
An error occurred while creating the OSPF area virtual
link.
An error occurred while creating the OSPF virtual link.
An error occurred while setting the OSPF area range:
{0}, {1}, false.
The maximum number of OSPF area ranges has been
exceeded.
The area ID is invalid. Use the DCC OSPF area ID,
LAN port area ID, or 0.0.0.0.
The mask is invalid.
The range address is invalid.
Your request has been denied because the timing source
information was updated while your changes were still
pending. Please retry.
The clock source for switching is invalid.
A switch cannot be made to a reference of inferior
quality.
Description
Choose an object of the specified type
to edit.
There was an error editing the item.
Refer to the error message text.
No specified terminations are selected.
CTC could not edit the specified
termination.
Refer to the error message text.
The authentication key cannot exceed
the specified number of characters.
Refer to the error message text.
CTC encountered an error while
creating the area virtual link.
CTC encountered an error creating the
virtual link.
CTC encountered an error while
setting the area range for the specified
values.
OSPF area ranges exceeded the
maximum number.
Refer to the error message text.
Refer to the error message text.
The range address is invalid. Try
again.
Refer to the error message text.
You have selected an invalid clock
source. Choose another clock.
Refer to the error message text.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
Error Messages Reference
503