Lpbkterminal (Ge) - Cisco NCS 2000 series Troubleshooting Manual

Alarm Troubleshooting

LPBKTERMINAL (GE)

Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: GE
A Loopback Terminal condition for a GE port occurs when a software terminal (inward) loopback is active
for an MXP_MR_2.5G, MXPP_MR_2.5G, TXP_MR_2.5G, and TXPP_MR_2.5G card client PPM (SFP)
provisioned at the ONE_GE port rate. For the TXP_MR_10E and TXP_MR_10G cards, this condition occurs
when there is a facility loopback on a client PPM (SFP) provisioned at the TEN_GE port rate.
For information about troubleshooting these circuits with loopbacks, refer to the
XP, or ADM-10G Circuit Paths With Loopbacks, on page 7
Clear the LPBKTERMINAL (GE) Condition
SUMMARY STEPS
1. Complete the
455
DETAILED STEPS
Complete the Clear an MXP, TXP, GE-XP, 10GE-XP, and ADM-10G Card Loopback Circuit, on page 455
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
LPBKTERMINAL (ISC)
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: ISC
A Loopback Terminal condition for an ISC port occurs when a software terminal (inward) loopback is active
for a TXPP_MR_2.5G or TXP_MR_2.5G client PPM (SFP) provisioned at the ISC port rate.
For information about troubleshooting these circuits with loopbacks, refer to the
XP, or ADM-10G Circuit Paths With Loopbacks, on page 7
Clear the LPBKTERMINAL (ISC) Condition
SUMMARY STEPS
1. Complete the
455
Clear an MXP, TXP, GE-XP, 10GE-XP, and ADM-10G Card Loopback Circuit, on page
procedure.
Clear an MXP, TXP, GE-XP, 10GE-XP, and ADM-10G Card Loopback Circuit, on page
procedure.
section.
http://www.cisco.com/c/en/us/support/index.html
section.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
LPBKTERMINAL (GE)
Troubleshooting MXP, TXP,
procedure.
Troubleshooting MXP, TXP,
297